Waterproof
100% taped seams
2-layer membrane
15000 mm Schmerber
Əsas menyu
Hədiyyə Kartlarını mağazamızdan əldə edə bilərsiniz
Əsas menyu
Kukilər siyasəti
Mən məxfilik siyasətində qeyd olunan şərtlərə uyğun olaraq məlumatlarımın işlənməsinə razılıq verirəm.Səbət
Səbətiniz boşdur
This waterproof sailing jacket will keep you warm and dry. Lined jacket, long cut (waxed), sleeves, high collar, covering hood, zipped pockets: a real plus when sailing!
Təhlükəsiz ödəniş
Biz həmçinin 150 avrodan yuxarı alış-verişlərdə 2, 3 və ya 4 dəfə ödəniş variantı təklif edirik.
Təhlükəsiz ödəniş
Biz həmçinin 150 avrodan yuxarı alış-verişlərdə 2, 3 və ya 4 dəfə ödəniş variantı təklif edirik.
Qaytarılma və dəyişdirilmə
Əşyalarınızı geri qaytarmaq üçün 90 gününüz var.
Əlavə məlumatı bu link vasitəsilə əldə edin.
Qaytarılma və dəyişdirilmə
Əşyalarınızı geri qaytarmaq üçün 90 gününüz var.
Əlavə məlumatı bu link vasitəsilə əldə edin.
100% taped seams
2-layer membrane
15000 mm Schmerber
Quilted lining (150 g/m2) provides very good insulation
High collar, 2-layer laminated fabric to counter the cooling effect of the wind
Dual-layer breathable lining (RET< 12): reduces condensation
15,000 mmH20
4 secure pockets, including 1 under a flap and 1 inner pocket
Materials and zips resistant to salt water and sea air.
Friction-resistant weave
20,000 cycles
Təsvir
Drying is a crucial phase in reactivating the water repellent treatment. We recommend that you lay your jacket flat on a clothes rack and leave it out to dry in the open. The radiator? Forget it! Then place them in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way round. Do not over-dry the garment.
The jacket is lined with 150 g/m2 quilting on the body and 100 g/m2 on the sleeves. This provides thermal protection and an incredible feeling of warmth (between -5 and -10 degrees).
We measure the fabric resistance to water pressure in mm of water column (based on the JIS standard). The higher the water pressure withstood by the fabric, the more waterproof it is. On our long warm 500 jacket: Component is resistant to water pressure of 15000 mm Schmerber (JIS standard). This equates to the average pressure applied by the water during a rain shower. The anorak’s waterproofness was tested in a rain shower with 60 litres of water/m²/hour for 2 hours.
- Long cut to keep you dry, even when sitting in the water - High collar - Injected plastic zip to prevent salt oxidation - Water repellent components (water runs off the fabric) - Fully taped seams - Central opening with flap and underflap with run-off groove for optimal waterproofing - Lycra cuff and sleeve adjustment
To find out whether a fabric is breathable, we test its evaporate resistance or RET (ISO 11092 standard). The lower the fabric’s resistance, the more moisture is evaporated, and therefore the higher the fabric’s breathability. We consider that if: RET < 9 = highly breathable fabric 9 < RET < 12 = breathable fabric The RET of waxed fabric is < 12.
The long cut of this jacket keeps you dry, even when you’re sitting in water, and provides warmth all over your body.
A fabric is water-repellent when water slides off the surface of the fabric, without seeping in. Your jacket does not become waterlogged and remains lightweight and breathable. The water-repellent properties are achieved with a treatment applied to the external side of the fabric, but in practice these properties can be altered.
The Lycra cuffs prevent air from entering at the wrists. A pleasing cocoon effect.
The hood does not pack down into the collar, it is attached. Completely depth and height-adjustable hood with quilted lining (100 g/m2). Visor to provide a good level of protection and a better hold. The high neck effectively protects the neck.
2 zipped pockets on the front lined with fleece, guaranteed warmth. 1 phone pocket accessible without opening the jacket. It is placed under the central flap. 1 inside pocket on the left chest with rip-tab closure The pockets are not waterproof!
Full-length zip with a quilted outer flap and inner flap with channel to provide protection from wind and water and prevent zip corrosion from salt exposure. The two-way zip allows you to open the jacket from the bottom for greater comfort during certain movements: crouching, climbing on board, stepping over ropes, and so on.
Təsvir
Drying is a crucial phase in reactivating the water repellent treatment. We recommend that you lay your jacket flat on a clothes rack and leave it out to dry in the open. The radiator? Forget it! Then place them in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way round. Do not over-dry the garment.
The jacket is lined with 150 g/m2 quilting on the body and 100 g/m2 on the sleeves. This provides thermal protection and an incredible feeling of warmth (between -5 and -10 degrees).
We measure the fabric resistance to water pressure in mm of water column (based on the JIS standard). The higher the water pressure withstood by the fabric, the more waterproof it is. On our long warm 500 jacket: Component is resistant to water pressure of 15000 mm Schmerber (JIS standard). This equates to the average pressure applied by the water during a rain shower. The anorak’s waterproofness was tested in a rain shower with 60 litres of water/m²/hour for 2 hours.
- Long cut to keep you dry, even when sitting in the water - High collar - Injected plastic zip to prevent salt oxidation - Water repellent components (water runs off the fabric) - Fully taped seams - Central opening with flap and underflap with run-off groove for optimal waterproofing - Lycra cuff and sleeve adjustment
To find out whether a fabric is breathable, we test its evaporate resistance or RET (ISO 11092 standard). The lower the fabric’s resistance, the more moisture is evaporated, and therefore the higher the fabric’s breathability. We consider that if: RET < 9 = highly breathable fabric 9 < RET < 12 = breathable fabric The RET of waxed fabric is < 12.
The long cut of this jacket keeps you dry, even when you’re sitting in water, and provides warmth all over your body.
A fabric is water-repellent when water slides off the surface of the fabric, without seeping in. Your jacket does not become waterlogged and remains lightweight and breathable. The water-repellent properties are achieved with a treatment applied to the external side of the fabric, but in practice these properties can be altered.
The Lycra cuffs prevent air from entering at the wrists. A pleasing cocoon effect.
The hood does not pack down into the collar, it is attached. Completely depth and height-adjustable hood with quilted lining (100 g/m2). Visor to provide a good level of protection and a better hold. The high neck effectively protects the neck.
2 zipped pockets on the front lined with fleece, guaranteed warmth. 1 phone pocket accessible without opening the jacket. It is placed under the central flap. 1 inside pocket on the left chest with rip-tab closure The pockets are not waterproof!
Full-length zip with a quilted outer flap and inner flap with channel to provide protection from wind and water and prevent zip corrosion from salt exposure. The two-way zip allows you to open the jacket from the bottom for greater comfort during certain movements: crouching, climbing on board, stepping over ropes, and so on.
Composition
Composition
0 rəy
Üzv kartı
Please log in to view your member card.
Üzv kartı
Please log in to view your member card.
Üzv kartı
Please log in to view your member card.
Üzv kartı
Please log in to view your member card.